Seagate ST3390N Guía de instalación descargar pdf (Pagina 67)

100

101

Installing the disk drives and tape drive 7-13

Disk drive diagrams

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

Disk drive diagrams

Introduction

Disk drives are mounted on a steel disk drive carrier, which also

holds the backplane connector and, for drive assemblies with

power packs, the power pack. The following diagrams of the

disk drives show the view from the disk drive carrier-side, and

show the drives as if the carrier were transparent.

You can identify a drive as Seagate, Maxtor, or DEC by

comparing the positions of the jumpers on the drive with the

diagrams. When you look at the jumper diagrams for Seagate

drives, imagine that you are looking at the side or end view of

the drive, with the disk drive carrier at the top.

A cutout on the disk drive carrier may allow you to see and

change jumper settings for the SCSI ID of a Maxtor drive.

Note 1: Cutouts are not present on the disk drive plate to

accommodate Seagate and DEC disk drives.

Note 2: The following disk drive diagrams show settings for the

primary and secondary disks. You should use the primary disk

settings for any disk drive in an unshadowed multi-node system.

You should only use the secondary disk setting for the

shadowing disk.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 67

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N