Seagate ST3390N Guía de instalación descargar pdf (Pagina 246)

100

101

14-16 Adding a node

Four- to five-node expansion (unshadowed)

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

Four- to five-node expansion (unshadowed)

Introduction

Node 5 is installed in the existing module that houses node 4.

Expanding from a 4- to

a 5-node unshadowed

system

To expand from a 4- to a 5-node unshadowed system, follow

these steps.

Step Action

1 Power down the system.

Note:

You must properly courtesy down the system before you

can power down. For more information on courtesy down

procedures, refer to the “System status and maintenance”

chapter in the

System Administration Guide

appropriate to your

site.

2 Insert the additional CEPS, Enhanced MMP40 board (module

MM1, slot 7), and disk drive (module MM1, slot MSU4) into

node 5. Refer to “Adding node 5 to an unshadowed system” on

page 14-17.

Note:

Before you install the disk unit, verify its jumper settings.

Refer to Chapter 7, “Installing the disk drives and tape drive.”

3 If you are going to have more than 24 ports, install a second

network loop cable from the Meridian 1 switch to the J5

connector on the backplane of module MM0. See Chapter 11,

“Installing the Meridian Mail to PBX interface,” for details.

4 If you are going to have more than 48 ports, do the following:

a. Install a utility card in module MM1, slot 5.

b. Install a third network loop cable from the Meridian 1 switch

to the J4 connector on the backplane of module MM1. See

Chapter 11, “Installing the Meridian Mail to PBX interface,”

for details.

c. Remove the EVB terminator, if there is one, from shroud S7

in module MM1.

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 246

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N