Seagate ST3390N Guía de instalación descargar pdf (Pagina 122)

100

101

9-16 Installing intramodule and intermodule cabling

Intermodule bus cable connection

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

You need two pairs of EVB cables (NT6P0111/8/9 or

NT6P0124/5/6, depending on which length you require). See

“Intermodule cabling for a three-module system” on page 9-15,

diagram B).

Installing EVB cables

between columns

The cabling between columns is identical to the intermodule

cabling described in this chapter, with the following cabling

restrictions:

• Cable routing follows the same routing restrictions for

column-to-column interface as outlined in SL-1 System

Installation Procedures (NTP 553-3001-210).

• Maximum cable length between modules is 244 cm

(96 in.). EVB cabling comes in three lengths: 76 cm

(30 in.), 152 cm (60 in.), and 244 cm (96 in.), with part

numbers NT6P0111/8/9 or NT6P0124/5/6 respectively.

Offset modules probably require the longer cables.

Step Action

1 If there is an EVB terminator in positions 1 and 0 of shroud S7

of module MM1 or module MM2, remove it. Label it as EVB

terminator, and store it safely.

2 Connect one end of an EVB cable from position 1 on shroud S7

of module MM0 to position 1 on shroud S5 of module MM1.

3 Connect one end of an EVB cable from position 0 on shroud S7

of module MM0 to position 0 on shroud S5 of module MM1.

4 Connect one end of an EVB cable from position 1 on shroud S7

of module MM1 to position 1 on shroud S7 of module MM2.

5 Connect one end of an EVB cable from position 0 on shroud S7

of module MM1 to position 0 on shroud S7 of module MM2.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 122

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N