Seagate ST3390N Guía de instalación descargar pdf (Pagina 164)

100

101

11-8 Installing the Meridian Mail to PBX interface

Installing the network loop

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

Using direct cabling

To install the Meridian Mail to PBX interface using direct

cabling, use “Network loop cabling between Meridian Mail and

Meridian 1” on page 11-6 as a reference, and follow these steps.

Step Action

3 With the enable/disable switch set to disable, install the

QPC414.

There are no other switches to set on this card. If you are

unfamiliar with how to install circuit cards, refer to

Circuit Card

Installation

(NTP 553-3001-211).

Once installed, both LEDs on the card light.

Note:

There are two options for Network loop cabling—direct or

indirect—by way of the I/O panel. Based on your equipment

configuration, you may need one or more cables to connect the

loop. For cabling routing information, refer to “Network loop

cabling between Meridian Mail and Meridian 1” on page 11-6.

4 If you are using direct cabling, follow the steps below. If you are

using indirect cabling follow “Using indirect cabling” on page

11-9.

Step Action

1 Install the direct loop cable QCAD124 at the Meridian 1

according to step a

b below, based on the loop number you

select in steps 1 and 2 of this procedure.

a. If the loop you select is an even number, install the cable in

the top slot (J1) of the network card.

b. If the loop you select is an odd number, install the cable in

the bottom slot (J2) of the network card.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 164

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N