Seagate ST3390N Guía de instalación descargar pdf (Pagina 60)

100

101

7-6 Installing the disk drives and tape drive

Disk installation (unshadowed systems)

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

Location of headers for SCSI settings

Note:

The disk drive illustrations show settings for the primary and

secondary disks. Use the primary disk settings for any disk drive in an

unshadowed multinode system. Use the secondary disk setting only for

the shadowing disk.

Installing disks in an

unshadowed system

To install disks in an unshadowed system, follow these steps.

Disk drive model See

Maxtor LXT340SY page 7-14

Seagate ST1480N page 7-15

Seagate ST3390N page 7-16

Seagate ST5660N page 7-17

Seagate ST11200 page 7-18

Maxtor MXT1240 page 7-19

DEC DSP3105 or DSP3107L page 7-20

Seagate ST51080N page 7-21

Seagate ST31230N page 7-22

Seagate ST32151N page 7-23

Seagate ST34573N page 7-24

2 Remove any jumpers on the header to set the SCSI ID of the

disk to 0.

Step Action

1 Power off the module.

2 If the faceplate that covers the disk drive or tape drive area is in

place, loosen the screws that hold it and slide the faceplate up

and out.

3 Lay the disk drive on a flat, stable surface, with the disk drive

carrier facing up. (See page 7-13 for a description.)

If the disk drive contains separators, ensure that the separators

are all present. Separators are little plastic disks that fit over the

screw holes and protect the disk drive from damage caused by

vibration.

4 Unpack each disk drive and ensure that it has the same part

number, including suffix, as the one on your packing slip.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N