Seagate ST3390N Guía de instalación descargar pdf (Pagina 210)

100

101

12-28 Configuring the Meridian 1

Programming the network loop

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

Programming the network loop

Introduction

Before you can begin to add ACD agents, you must program the

network loop. Refer to the X11 Input/Output Guide

(NTP 553-3001-400), Release 18 document, to complete this

procedure.

Programming the

network loop

To program the network loop, follow these steps.

Step Action

1 Load Overlay 22 and print out the configuration record. Refer to

“Overlay 17—Configuring the network loop” on page 12-29.

Read the configuration record to select a loop that is not

already reserved.

Note:

Meridian Mail EC supports only double-density loops.

The maximum number of channels per loop is 24. The Utility

card supports a maximum of 48 channels. Meridian Mail can

have up to 96 channels.

2 Load Overlay 17 and configure the network loop as outlined in

the

X11 Input/Output Guide

(NTP 553-3001-400). Refer to the

section “Common Equipment, CEQU.”

3 Program the Meridian Mail loop by responding to the prompts

shown in “Overlay 17—Configuring the network loop” on page

12-29.

4 Print out the configuration record to verify your programming.

Your configuration record will be similar to the example in

“Example of a configuration record printout” on page 12-29.

In this case, Loop 34 could support Meridian Mail.

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 210

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N