Seagate ST3390N Guía de instalación descargar pdf (Pagina 65)

100

101

Installing the disk drives and tape drive 7-11

Disk installation (shadowed systems)

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

Setting the SCSI ID for

a primary disk

To set the SCSI ID for a primary disk, follow these steps.

Setting the SCSI ID for

a secondary disk

To set the SCSI ID for a secondary disk, follow these steps.

Step Action

1 To find the header locations for the primary disk drive, use

“Location of headers for SCSI settings” on page 7-6 to

determine the figure to which you should refer.

Note:

To set the termination header, you must remove the disk

drive carrier. To remove the disk drive carrier, see step 2 in

“Installing disks in a shadowed system” on page 7-12.

2 Set the SCSI ID of the primary disk to 0 by removing any

jumpers on the header. See the disk drive illustrations in this

chapter for the locations of the jumpers.

When you remove these jumpers, the SCSI ID of the disk sets

to 0.

Step Action

1 To find the header locations for the secondary disk drive, use

“Location of headers for SCSI settings” on page 7-6 to

determine the figure to which you should refer.

Note:

To set the termination header, you must remove the disk

drive carrier. To remove the disk drive carrier, see step 2 in the

following procedure.

2 Set the SCSI ID of the secondary disk to 2 by removing any

jumpers, or inserting a jumper, on the header. See pages 7-14

to 7-24 for the locations of jumper settings for the secondary

disk.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 65

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N