Seagate ST3390N Guía de instalación descargar pdf (Pagina 166)

100

101

11-10 Installing the Meridian Mail to PBX interface

Installing the network loop

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

4 If you have more than one network loop cable, connect the

cables as outlined in the following steps:

a. Connect the first network loop cable to J4 of the first module.

b. Connect the second network loop cable to J5 of the first

module.

c. If the system has more than 48 channels, you need an

additional network loop cable and a second utility card.

Connect the third loop to J4 of the module that contains the

second utility card.

d. If the system has more than 72 channels, you need a fourth

network loop cable. Connect this loop to J5 of the module

that contains the second utility card.

e. Enter the Meridian 1 loop numbers in the Meridian Mail

configuration. Refer to the chapter on hardware

administration in the

System Administration Guide

(NTP 555-7001-30x).

5 Connect the I/O to I/O cables (NT8D73AD/F/L/S) from the LP0

and LP1 connectors on the Meridian Mail I/O panel to the

Meridian 1 I/O panel.

6 Set the switch on the faceplate of the QPC414 network card to

“enable.”

The LEDs remain on.

Step Action

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 166

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N