Seagate ST3390N Guía de instalación descargar pdf (Pagina 61)

100

101

Installing the disk drives and tape drive 7-7

Disk installation (unshadowed systems)

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

5 Follow the procedure for setting the SCSI ID for an

unshadowed disk to verify that the SCSI ID on the drive is set

to 0.

6 Verify that there is no terminator attached to the disk. Refer to

the disk drive illustrations for terminator locations for each type

of disk drive.

7 Verify that all other settings (for example, parity and motor start)

are correctly set. Refer to the disk drive illustrations for disk

drive settings.

8 Replace the disk drive carrier if it was removed.

Verify that all separators are present.

9 Open the ejectors and align the disk drive carrier with the

appropriate MSU slot in the module. (For disk slot locations

within the module, refer to “Location of disk drives in an

unshadowed system” and “Location of disk drives for each

node in an unshadowed system” on page 7-4.)

10 Gently slide the card into the module, pushing on the upper and

lower edges until the disk drive is fully seated in the module.

11 Close the ejectors.

12 Replace the faceplate.

Step Action

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 467 468

Comentarios a estos manuales

Sin comentarios

Seagate ST3390N Guía de instalación Pagina 61

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Seagate ST3390N