Seagate ST31230N/ND Guía de instalación descargar pdf (Pagina 59)

Installing the disk drives and the tape drive 6-13

Installing the external tape drive

Standard 1.0 Option 11 EC Installation and Maintenance Guide November 1999

4 Ensure that power to the EC 11 is turned off. Remove

the SCSI terminator (A0376979) from the external

SCSI connector on the right end of the EC 11 I/O

panel, and plug the other end of the SCSI cable into

the connector.

5 Attach the grounding wire at the EC 11 end of the

cable to the most convenient grounded self-tapping

screw on the EC 11 cabinet apron.

6 Mounting brackets for the Tandberg or Archive tape

drive are available separately (kit NTAK39AA).

a. If supplied, use the mounting brackets and

screws to mount the external tape drive to the

wall, below and to the right of the EC 11

cabinet.

b. Mount the drive horizontally with the bottom of

the unit toward the wall. You may elect to have

the front facing left or right for convenience.

Mount the unit so that it does not interfere with

the cables that run out of the bottom of the EC

11 cabinet.

7 Plug the tape drive’s power cord into the same power

circuit used by the EC 11 cabinet.

CAUTION

Risk of equipment damage

Do not attempt to remove a tape when the

unit is running.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 271 272

Sin comentarios

Seagate ST31230N/ND Guía de instalación Pagina 59