Seagate ST31230N/ND Guía de instalación descargar pdf (Pagina 53)

Installing the disk drives and the tape drive 6-7

Assembling and installing the disk drives

Standard 1.0 Option 11 EC Installation and Maintenance Guide November 1999

3 Ensure that the SCSI ID on the secondary drive (with

the power pack) is set to 2 as follows:

a. Find the ID pins on the disk. See the

corresponding diagram in this section for the

ID pin locations.

b. Remove any jumpers on the header on the

first and third pin positions. Insert a jumper

on the header in the second pin position.

See the appropriate diagram in this section

for the location of the jumper.

This sets the SCSI ID of the disk to 2

4 Ensure that parity is enabled. See the corresponding

diagram for jumper settings.

5 Ensure that terminators are disabled by removing

the Terminating Enable (TE) jumper. See the

corresponding diagram.

6 Ensure that the MSU plates are installed in their slots,

and that their screws are securely fastened.

7 Install the disk cover plates for each individual disk

drive plate by sliding them in between the disk and

the disk drive plate so that the front of each disk is

covered.

8 Install the disk drive plates to the MSU plates in slot

10 and slot 12 by opening the locklatches, aligning

the drive plate to the MSU plate, gently sliding the

drive plate into the MSU plate, and closing the

locklatches.

Note:

Install the drive plates with the auxiliary power

packs in slot 12.

9 Install the disk faceplate over the MSU area.

CAUTION

Risk of equipment damage

When the EC 11 is powered up with the

cover open and the disk cover plates

removed, do not allow metal objects or the

antistatic wrist strap to come into contact

with exposed disk drive header pins.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 271 272

Sin comentarios

Seagate ST31230N/ND Guía de instalación Pagina 53