Seagate ST31230N/ND Guía de instalación descargar pdf (Pagina 243)

Hardware maintenance 16-11

Removing and replacing the disk unit in a shadowed EC 11

Standard 1.0 Option 11 EC Installation and Maintenance Guide November 1999

12 Enable disk shadowing.

Note: The node can remain with the disk with the

power supply as SCSI address = 0 and the disk

without the power supply as SCSI address = 2.

However, for consistency and to avoid confusion, it is

recommended that you switch the SCSI IDs so that

the primary disk is SCSI address = 0 (without the

power supply) and the secondary disk is SCSI

address = 2 (with the power supply). To do this,

perform the remaining steps in this procedure.

13 When the disks are synchronized and shadowing is

enabled, courtesy down the system.

14 Power down the system.

15 Remove the disks. Change the SCSI address of the

disk with the power supply to 2, and the disk without

the power supply to 0.

16 Install the disk cover plates by sliding them between

the disks and the disk drive plates so that the front of

each disk is covered.

17 Reinstall the disks, power up the system, and start

Meridian Mail.

1 2 ... 238 239 240 241 242 243 244 245 246 247 248 ... 271 272

Sin comentarios

Seagate ST31230N/ND Guía de instalación Pagina 243