Seagate ST118273WC Guía de usuario descargar pdf (Pagina 79)

Attaching Devices to the Asynchronous Serial Interface

HP-UX version 11.00.01 Configuring Asynchronous Serial Interfaces 7-7

2. Instruct the system to use the new (latest) /etc/inittab settings by entering

init q

3. Add an (optional) entry to /etc/ttytype. Entries should conform to the

format documented on the ttytype(4) man page. The following are two sample

entries:

2392 console

2392 tty0p3

2392 is the terminal type, while console and tty0p3 are the device file

names in the /dev directory.

4. The HP-UX operating system will now communicate with the new terminal.

Verify that the communication parameters for the terminal correspond to their

/etc/gettydefs entries. With the configuration complete, your terminal

should display a login prompt.

Modem Interface Configuration

To add a modem, you need to configure the HP-UX operating system to recognize

both the serial port and the modem protocol. Read the following procedure and

the modem documentation before starting configuration.

NOTE

This procedure does not refer to the RSN modem, which is set up

according to the procedures documented in the HP-UX Operating

System: Fault Tolerant System Administration (R1004H).

Use the following procedure to configure a modem through the SAM interface:

1. Invoke the SAM interface by entering

sam

2. From the initial screen, move through the following menus:

Peripheral Devices -> Stratus Devices -> ASYNC SERIAL INTERFACE ->

ADD TERMINAL/MODEM. (SAM includes online help if you need assistance.)

3. You are presented with a series of prompts. Enter the appropriate information

as requested.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 85 86

Sin comentarios

Seagate ST118273WC Guía de usuario Pagina 79