Seagate ST118273WC Guía de usuario descargar pdf (Pagina 42)

Configuring Console Controller Serial Ports

3-2 Peripherals Configuration (R1001H) HP-UX version 11.00.01

The console controllers support three serial ports, a console port, a port reserved

for the RSN modem, and an auxiliary port that you can use for various purposes

(for example, an external UPS). The ports are located on the back of the system base

or cabinet in a Continuum system. The port assignments are as follows:

Port 0 Console

Port 1 Remote Service Network (RSN)

Port 2 Auxiliary port (for UPS or secondary console)

By default, the ports are configured as shown in Table 3-1.

Normally, you do not need to change these settings. However, you can change a

port configuration by burning a new config partition in the console controller.

To burn a new config partition, do the following:

1. Check your console terminal manual, and any other devices that you need to

connect to one of the serial ports, to determine the correct line settings.

2. Determine which console controller is on standby. To do this, enter

ftsmaint ls 1/0

ftsmaint ls 1/1

Look for Online Standby in the Status column; this state identifies the

standby console controller (the online controller lists an Online state). Note

the location, either 1/0 or 1/1 in the H/W Path column.

NOTE

You must specify the standby board for any console controller

board-burning commands. You will get an error if you specify the online

board.

Table 3-1. Console, RSN, and Auxiliary Port Configuration

Console Port RSN Port Auxiliary Port Auxiliary Port for

UPS

9600 baud 9600 baud 9600 baud 2400 baud

7 bits 7 bits 7 bits 8 bits

odd parity odd parity odd parity no parity

1 stop bit 1 stop bit 1 stop bit 1 stop bit

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 85 86

Sin comentarios

Seagate ST118273WC Guía de usuario Pagina 42