Seagate ST118273WC Guía de usuario descargar pdf (Pagina 45)

Configuring Console Controller Serial Ports

HP-UX version 11.00.01 Configuring Serial Ports for Terminals and Modems 3-5

6. To activate the new settings, the standby console controller you just updated

must become the online console controller. To switch the status of both

controllers (online becomes standby and vice versa), enter

ftsmaint switch hw_path

hw_path is the hardware path of the standby console controller (as

determined in step 2), which is either 1/0 or 1/1. For example, if the standby

console controller is located at 1/0, enter

ftsmaint switch 1/0

7. Check that the status of the newly updated console controller board is Online

and that the other console controller board is Online Standby. To do this,

enter

ftsmaint ls 1/1

ftsmaint ls 1/0

The Status values should be the opposite of those observed in step 2.

8. Update the PROM code on the console controller that is now on standby by

repeating steps 3–5 for this console controller. Once this is completed, both

console controllers will be updated with the new configuration.

9. To return the boards to the state in which you found them, switch the status of

the two console controllers again. To do this, enter

ftsmaint switch hw_path

hw_path is the hardware path of the new standby console controller (as set in

step 6). For example, if the standby console controller is located at 1/1, enter

ftsmaint switch 1/1

10. To verify that the boards have returned to the appropriate state, and that the

Firmware Rev has been updated with the revision number of the PROM files

you just used to update them, repeat step 2.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 85 86

Sin comentarios

Seagate ST118273WC Guía de usuario Pagina 45