Seagate ST118273WC Guía de usuario descargar pdf (Pagina 71)

Configuring a CD-ROM Drive

HP-UX version 11.00.01 Configuring CD-ROM Drives 6-3

b. For Continuum Series 600 and 1200 systems, check the location of the

CD-ROM drive by entering

ftsmaint ls

Check for addresses that are already used. The new CD-ROM can use any

other legal address.

3. Install the CD-ROM hardware, following instructions provided in the

hardware documentation.

4. For Continuum Series 400 systems only, turn on power to the CD-ROM drive.

5. Configure the device into the system by entering

addhardware

Executing this command:

– updates the ioconfig file

– identifies the new CD-ROM drive to the operating system

– associates it with its device driver

– creates the character and block device special (/dev) files required to

communicate with the CD-ROM drive.

See the addhardware(1) man page for more information.

6. Verify that the CD-ROM is configured into the system by entering the

following commands:

ioscan -fn -C disk

ftsmaint ls hw_path

hw_path is the hardware path to the CD-ROM. Confirm that the CD-ROM is

present, CLAIMED, and Online, and that device special files have been created

for it in the /dev/dsk and /dev/rdsk directories. (There is substantial

overlap between the ftsmaint and ioscan commands, but the ftsmaint

command does not include the device file names and the ioscan command

does not include the Status information.)

7. To use the CD-ROM drive, insert a CD-ROM and mount the media by entering

mount device_file /SD_CDROM

device_file is the device file name for the CD-ROM drive.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 85 86

Sin comentarios

Seagate ST118273WC Guía de usuario Pagina 71