Seagate ST39175LW Guía de usuario descargar pdf (Pagina 37)

Chapter 2, Hardware Configuration 27

General Procedure

◆ On UNIX hosts, create any required device files.

Create the device files for each tape and disk drive based on the fibre channel LUNs of

the drives and adapters (explained under “Configuration Steps” on page 33). Add the

name of the device file to your notes to complete the correlation between device files

and physical drive location.

Use the NetBackup Media Manager Device Configuration Guide and the man pages that

are available with the operating system.

◆ Customize the Solaris operating system by modifying the appropriate system

configuration files. This task requires knowledge of the system files that influence

device file creation and use.

You may need to modify the sg driver files. See the NetBackup Media Manager Device

Configuration Guide.

◆ Use the interface available for each piece of hardware to ensure that the configuration

is correct.

Use the following order to configure and verify the hardware (start with the robot and

shared drives and work back to the host):

a. Tape robotics and drives

b. Bridges and routers

c. Hub or switches

d. Solaris servers

◆ If you experience errors during the installation and configuration of your devices and

you suspect that your Solaris configuration is causing problems, refer to the operating

system logs as described in your operating system documentation.

Media Manager Device Configuration Guide

See the NetBackup Media Manager Device Configuration Guide for information on installing

and configuring drivers, and modifying the appropriate system configuration files.

NetBackup 4.0V ServerFree Agent System Administrator's Guide for Solaris

TechNote 235522

TechNote 233952

TechNote 234175

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 103 104

Sin comentarios

Seagate ST39175LW Guía de usuario Pagina 37