Seagate ST12550WD Guía de usuario descargar pdf (Pagina 20)

KZPSA PCI-to-SCSI Storage Adapter

3–2 EK–KZPSA–UG. B01

3.2 Hardware Installation Procedure

CAUTION

Static electricity can destroy the circuits on the

KZPSA adapter. Discharge static electricity by

touching the system box's metal frame before

handling the KZPSA module or any other mod-

ules.

1. Power down your computer and remove the covers to access the mother-

board. Refer to your host system manual for general instructions on install-

ing adapters.

NOTE

Two board extender guides are included in the

KZPSA Adapter Kit; one factory-installed and one

optional guide for alternate system configurations.

If the installed extender does not fit in your sys-

tem, replace it with the other extender as shown in

Figure 3–1.

2. Install the KZPSA adapter board in your host computer; the board connec-

tor is held in place with a screw you remove from a blank panel as shown in

Figure 3–1. Replace the factory-installed guide with the correct configura-

tion for your system if necessary.

3. Replace your host computer covers; refer to your host computer manual.

4. Connect the SCSI cable as shown in Figure 3–2.

5. The KZPSA adapter is now physically installed. However, you must power

on your system to have the host firmware recognize and configure the

KZPSA adapter.

6. Power on your host computer. Proceed to Chapter 4 for OpenVMS AXP or

DEC OSF/1 systems. Proceed to Chapter 5 for Windows NT AXP systems.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 66 67

Sin comentarios

Seagate ST12550WD Guía de usuario Pagina 20