Seagate ST12550WD Guía de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 67
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
EK–KZPSA–UG. B01 2–1
2
Configuration Guidelines
Before you install the KZPSA PCI-to-SCSI storage adapter in your computer, you need to be-
come familiar with the configuration guidelines for the host adapter and its SCSI bus. This chap-
ter will help you plan your system configuration. It discusses the SCSI bus configuration, bus
termination and power, and describes bus signals and their functions.
2.1 Configuration Defaults
Your KZPSA adapter has been configured at the factory as follows:
Adapter Attribute Default Reason to change
SCSI ID 7 If there are multiple SCSI adapters on the same
SCSI bus.
SCSI Termination Present Yes If KZPSA is not at one end of the bus.
SCSI Termination Power Yes If too many nodes supply termination power, there
is a potential safety issue because too much current
is available.
SCSI Fast Data Transfer Yes If there are single ended segments greater than 3
meters.
SCSI Bus Reset on Boot No To allow SCSI bus resets during Boot.
Device Attribute Default Reason to change
Wide Negotiation Yes If the device is incompatible with wide negotiation.
Synchronous Negotiation Yes If the device is incompatible with synchronous ne-
gotiation.
Tagged Queuing Yes If the device is incompatible with tagged command
queuing.
Disconnect Yes To improve single device performance.
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 66 67

Comentarios a estos manuales

Sin comentarios