Seagate ST12550WD Guía de usuario Pagina 17
- Pagina / 67
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
KZPSA PCI-to-SCSI Storage Adapter
2–4 EK–KZPSA–UG. B01
2.5 SCSI Termination Power
It is normal for adapters, not devices, to supply termination power to the SCSI
bus. The KZPSA adapter is configured at the factory to supply 1.5 amps of ter-
mination current. Although each SCSI node may supply termination power to the
bus, a single source from the host adapter is sufficient. No more than four
sources of termination power on a SCSI bus is recommended.
2.6 SCSI Fast Data Transfers
Eight-bit devices that allow fast data transfers will transfer data at rates greater
than 5 Mbytes/sec., usually at the normal 10 Mbytes/sec. rate. The actual speed
is negotiated between the adapter and the device at the start of a transfer. If dis-
abled, this will be limited to 5 Mbytes/sec. This allows for single-ended bus
segments that exceed the three meter fast limit and, therefore, must be speed re-
stricted.
2.7 SCSI Bus Reset-on-Boot
For some high-availability configurations, SCSI bus resets on system boot are not
desired as there may be another adapter on the same bus. This defaults to no
SCSI bus resets sent on the bus during boot, but can be configured to issue them.
2.8 Device Wide Negotiation
Because some older devices fail to conform to the SCSI specification for wide
negotiation, they may not be recognized by the KZPSA unless wide negotiation
is disabled. The adapter default allows wide negotiation.
2.9 Device Synchronous Negotiation
Because some older devices fail to conform to the SCSI specification for syn-
chronous negotiation, they may not function correctly unless synchronous nego-
tiation is disabled. The adapter default allows synchronous negotiation.
2.10 Device Tagged Queuing
Because some older devices fail to conform to the SCSI specification for tagged
command queuing, they may not function correctly if tagged command queuing
is allowed. The adapter default allows tagged command queuing.
- KZPSA PCI-to-SCSI 1
- Storage Adapter 1
- Contents 3
- EK–KZPSA–UG. B01 v 5
- Revision Record 6
- About This Guide 7
- Associated Documents 9
- Conventions 9
- Product Description 10
- 1–2 EK–KZPSA–UG. B01 11
- EK–KZPSA–UG. B01 1–3 12
- 1.2 Standards 13
- 1.3 Specifications 13
- Configuration Guidelines 14
- 2.3 SCSI Bus Configuration 15
- 2.2 PCI Bus Configuration 15
- 2.4 SCSI Bus Termination 16
- 2–4 EK–KZPSA–UG. B01 17
- 2.11 Device Disconnects 18
- Installing the KZPSA Adapter 19
- 3–2 EK–KZPSA–UG. B01 20
- EK–KZPSA–UG. B01 3–3 21
- 3–4 EK–KZPSA–UG. B01 22
- EK–KZPSA–UG. B01 3–5 23
- OpenVMS AXP and OSF/1 Systems 24
- 4–2 EK–KZPSA–UG. B01 25
- 4.4 KZPSA SCSI ID 26
- 4.5 SCSI Termination Power 26
- 4.6 SCSI Fast Data Transfer 26
- 4.7 KZPSA Device Booting 27
- Windows NT AXP Systems 28
- 5–2 EK–KZPSA–UG. B01 29
- EK–KZPSA–UG. B01 5–3 30
- 5–4 EK–KZPSA–UG. B01 31
- KZPSA Adapter Utilities 32
- 6–2 EK–KZPSA–UG. B01 33
- Table 6–1 Keyboard Functions 33
- Key Function 33
- EK–KZPSA–UG. B01 6–3 34
- 6–4 EK–KZPSA–UG. B01 35
- Figure 6–1 Initial Screen 35
- EK–KZPSA–UG. B01 6–5 36
- Figure 6–2 Options 36
- 6–6 EK–KZPSA–UG. B01 37
- Figure 6–3 SCSI Options 37
- EK–KZPSA–UG. B01 6–7 38
- 6–8 EK–KZPSA–UG. B01 39
- Figure 6–5 Diagnostics 39
- EK–KZPSA–UG. B01 6–9 40
- Figure 6–6 Error Log Example 40
- 6.3 Firmware Update Utility 41
- EK–KZPSA–UG. B01 6–11 42
- Troubleshooting 43
- 7.2 System Power-on Problems 44
- 7.3 SCSI Device Problems 45
- 7–4 EK–KZPSA–UG. B01 46
- Continued) 46
- 7.4 Boot Sequence Problems 47
- Release Notes 48
- Verified Device Listing 49
- Mandatory Console Code Update 50
- Restrictions 51
- Additional Information 52
- B.1 Configuration Summary 53
- B.2.2 SCSI ID Selection 54
- B.2.3 SCSI Bus Termination 54
- EK–KZPSA–UG. B01 B–3 55
- B.3.2 SCSI ID Selection 56
- B.3.3 SCSI Bus Termination 56
- EK–KZPSA–UG. B01 B–5 57
- B–6 EK–KZPSA–UG. B01 58
- EK–KZPSA–UG. B01 B–7 59
- B.4.2 SCSI ID Selection 60
- B.4.3 SCSI Bus Termination 60
- Glossary 61
- G–2 EK–KZPSA–UG. B01 62
- EK–KZPSA–UG. B01 G–3 63
- G–4 EK–KZPSA–UG. B01 64
- EK–KZPSA–UG. B01 G–5 65
- Reader’s Comments 66
© 2020, manymanuals.es. Todos los derechos reservados | 0.178 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales