
10.11
InForm OS Version 2.2.4 Command Line Interface Reference
Change Notification (RSCN) message is issued to the fabric controller whenever a VLUN is
created or removed. In addition, if enabled with a public loop topology, a Loop
Initialization (LIP) is issued from the port whenever a VLUN is created or removed. See
Specifiers on page 10.14 for additional information on parameters required to issue this
subcommand.
persona
Sets the port persona that specifies the personality (specifications) of the device connected
to a port. See Specifiers on page 10.14 for parameters required to issue this subcommand.
nssync
Verifies current port database against the Name Server when a fabric is attached. Entries
present in the database but missing from the Name Server are removed. Note that the use
of this command is not required under normal circumstances.
rcip addr
Sets the Remote Copy interface to use the specified IP address and netmask. See Specifiers
on page 10.14 for parameters required to issue this subcommand.
rcip gw
Sets the gateway for one or more Remote Copy interfaces. Only for RCIP ports. See
Specifiers on page 10.14 for parameters required to issue this subcommand.
rcip delete
Deletes the configuration for one or more specified Remote Copy interfaces. See Specifiers
on page 10.14 for parameters required to issue this subcommand.
rcip mtu
Sets the Maximum Transfer Unit (MTU) size for the specified Remote Copy interface(s),
overriding the default of 1500. The largest supported value is 9000 and the smallest is 100.
Only for RCIP ports. See Specifiers on page 10.14 for parameters required to issue this
subcommand.
rcip state up|down
Sets the specified Remote Copy interface(s) as either up or down. Only for RCIP ports. See
Specifiers on page 10.14 for parameters required to issue this subcommand.
rcip speed
Instructs the specified Remote Copy interface(s) to use the specified speed and duplex, or to
auto negotiate speed and duplex. The default is auto. Only for RCIP ports. See Specifiers
on page 10.14 for parameters required to issue this subcommand.
Comentarios a estos manuales