Seagate ST5660A Guía de instalación descargar pdf (Pagina 17)

• Use another drive type or translation geometry. Sometimes

the computer’s BIOS does not accept a particular translation

geometry value for writing into the CMOS Setup memory.

• Change the interrupt jumper setting on the host adapter.

• Check for media defects at the beginning of the drive. Use a

third-party surface scan utility.

The FDISK error message, “No Fixed Disk Present,” appears.

• Check all cables.

• Make sure the power supply is adequate to system needs.

• Reboot the computer and make sure the drive spins up.

• Verify the CMOS setup drive-type setting.

• Check for I/O address conflicts.

DOS messages, “Disk Boot Failure,” “Non-System Disk,” or

“No ROM Basic - SYSTEM HALTED,” appear.

• Check all cables.

• Use the same version of DOS throughout all partitions.

• Reinstall the DOS system files using the DOS SYS utility.

• Use FDISK to verify that the primary partition is active.

• Check for viruses.

System error message, “Drive not Ready,” appears.

• Check all cables. For each drive ribbon cable, verify that cable

pin 1 is aligned with drive or host pin 1. Pin 1 is usually denoted

by a stripe on the side of the ribbon cable.

• Make sure the power supply is adequate to system needs.

• Reboot the computer and make sure the drive spins up.

ST5660A Installation Guide, Rev. B 15

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Seagate ST5660A Guía de instalación Pagina 17