Seagate ST5660A Guía de instalación

. . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . .ST5660A. . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . AT Inter

Figure 3. Recommended mounting orientations8 ST5660A Installation Guide, Rev. B

Configuring the computerConfigure your computer for the drive as follows:1. Turn the computer on and follow the manufacturer’s instructi-ions for runn

If your Setup routine does not offer a user-defined drive type,select a standard drive type with a capacity that most closelyapproximates, but does no

High-level formattingHigh-level formatting verifies the information written by the low-level format and builds the file allocation table (FAT) used by

• Verify the CMOS drive type setting. The drive type settingstored in CMOS memory using CMOS Setup must approxi-mate, but not exceed, the physical spe

If a warm boot causes a previously unrecognized drive tobecome recognized, there may be a timing problem in whichthe drive fails to become rea

• Use the same version of DOS within all partitions. Make surethat the DOS version the dealer used to partition and high-levelformat the drive is the

• Use another drive type or translation geometry. Sometimesthe computer’s BIOS does not accept a particular translationgeometry value for writing into

During the DOS high-level format, the drive does not formatto full capacity.• Verify your computer’s CMOS drive type setting. One of theseproblems may

SeaFAX. 408/438-2620You can use a touch-tone telephone to access Seagate’sautomated FAX system to receive technical support informa-tion by retur

© 1994 Seagate Technology, Inc. All rights reservedPublication Number: 36265-001, Rev. BJune 1994Seagate®, Seagate Technology® and the Seagate l

SeaBOARDUsing a modem, you can:• Access documentation, drive specifications and jumper set-tings for Seagate’s entire product line.• Download software

Storing and shipping your driveKeep your original box and packing materials for storing orshipping your drive. The box has a Seagate Approved

Seagate Technology, Inc.920 Disc Drive, Scotts Valley, CA 95066, USAPublication Number: 36265-001, Rev. B, Printed in USA

Read before you begin...Application. This Seagate® drive is designed for IBM AT andcompatible personal computers. It uses the ATA interface.Warning. T

Maintenance and repair. Seagate drives do not require mainte-nance. The head/disc assembly is sealed; a broken seal voidsthe warranty. Seagate custo

Configuring the drive1. Turn the computer off.2. Remove your computer’s outer case.Caution. Special training or tools may be needed to serviceportable

J8. Options jumper blockCircuitboard11129107856341314121516171819202122333431322930272825262324One drive onlyDrive is master;slave

•If you are not using cable select and instead are using astandard ATA interface cable, configure the drive as amaster or a slave as shown in

J3. Standardpower connector+5V+5V return+12V return+12V1234CircuitboardJ1. InterfaceconnectorJ1 pin 1J8 pin 1Figure 2. ST5660A Connectors6 ST56

Two-drive system with standard ATA 40-pin interface cable:If you are using a standard 40-pin two-drive ribbon cable, plugone connector into J1 on each