Seagate ST500LM020 Guía de usuario descargar pdf (Pagina 5)

Installation | Wave Systems Corp.  2012

ESC 2.9.5 Client Manual

2. Installation

ESC can be installed interactively or silently following the instructions in this section. Antivirus software

can interfere with the installation, so it is recommended this be disabled. It is also recommended that

other open programs be shut down to prevent them from interfering with the installation. Running

critical Windows updates can interfere with the installation, so it is recommended to Update Windows

prior to installing ESC. A reboot is always required after ESC is installed; however the SED can be

managed prior to the reboot.

2.1. Prerequisites

2.1.1. Hardware

NOTE: See http://www.wave.com for a list of supported hardware providers.

• PC with a Pentium or newer microprocessor, 800 MHz or greater

• OPTIONAL: Trusted Platform Module (TPM) v 1.2

A firmware update may be required

• OPTIONAL: Biometric sensor for Fingerprint support

A list of supported sensors is found in the Biometrics section

• OPTIONAL: Seagate or Opal Compliant Self-Encrypting Drive (SED)

2.1.2. Supported Operating Systems

• Microsoft Windows 7, 32 or 64 bit Professional, Enterprise, or Ultimate

• Microsoft Windows Vista SP2 (or higher), 32 bit or 64 bit, Enterprise or Ultimate

• Microsoft Windows XP Professional SP3 (or higher), 32 bit or SP2 64 bit

o (.Net Framework 3.5 SP1 needs to be installed separately)

2.1.3. Other Requirements

• Microsoft(R) Internet Explorer version 6.1 or greater.

• For Macrovision-protected versions of ESC: Internet access is required to activate the software.

• Wave software does NOT support the IFX TSS on 64-bit platforms. If the endpoint’s operating

system is a 64-bit edition, then ensure that IFX TSS is not installed (or uninstalled) on the

endpoint before installing ESC.

1 2 3 4 5 6 7 8 9 10 ... 62 63

Sin comentarios

Seagate ST500LM020 Guía de usuario Pagina 5