Seagate Medalist 1721 Guía de instalación descargar pdf (Pagina 30)

26 Medalist 1721, 1010, Rev. B

•

Your setup system diskette may be corrupted. Try using a

backup diskette.

•

Make the partitions smaller.

•

Change the interrupt jumper setting on the host adapter.

•

Some BIOS have a Track 0 protection feature that protects

Track 0 from viruses. This may cause FDISK to hang the sys-

tem. You must disable this feature in the system setup pro-

gram before you can use FDISK. See your computer reference

guide for assistance. Be sure to re-enable this important fea-

ture when FDISK is done.

The system error message, “Drive not Ready,” appears.

•

Check all cable connections. Make sure pin 1 of the drive is

connected to pin 1 of the hard-disc controller or host adapter.

•

Make sure the power supply is adequate for system needs.

•

Reboot the computer and make sure the drive spins up.

The FDISK error message, “No Fixed Disk Present,”

appears.

•

Make sure the power supply is adequate for system needs.

•

Verify the drive-type values in the system setup program.

•

Check for I/O address conflicts.

The drive does not format to full capacity.

•

Verify the drive-type values in the system setup program. One

of the following problems may have occurred:

– The values may be set with an incorrect translation charac-

teristic.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Sin comentarios

Seagate Medalist 1721 Guía de instalación Pagina 30