Seagate ST3300007LW Guía de usuario descargar pdf (Pagina 9)

SCSI Hammer™ Quick Start

SCSI Hammer™ Users Guide

Page 9 of 89

Out of the box, your SCSI Hammer™ is ready to start erasing

drives. To quickly clear all data from SCSI Drives:

1. Connect data cables to as many as two (2) SCSI

Drives (one ‘A Side’ of SCSI Hammer™ and one on ‘B

Side’ of SCSI Hammer™)

Connect data cables to as many as two (2) external SCSI enclosures, backplanes,

shelves or other external SCSI mechanisms – this feature allows for the

simultaneous erasure of up to thirty (30) drives!

SCSI Hammer™ Notes:

SCSI Hammer™ can reliably

power up to two (2) modern 3.5”

form factor SCSI Drives. Legacy

SCSI drives, such as 5.25” form

factors and others may require

an external power source.

2. If drives are connected directly to SCSI Hammer™, attach power cables to each side

of SCSI Hammer™ and connect them to each of the attached drives.

3. Power on SCSI Hammer™ by pressing the red ‘Power’ button.

• Wait for SCSI Hammer™ to ‘Scan for Drives’.

4. When the LCD displays ‘Start’, press the RIGHT navigation button to initiate the

erasure process on all attached drives simultaneously.

That’s all there is to it!

NIST 800-88 Compliance:

NIST 800-88 defines ‘clear’ and ‘purge’ requirements for data storage devices, including hard

drives. SCSI Hammer™ conforms to NIST 800-88 ‘purge’ requirements when configured to

perform “SCSI Secure Erase”.

The SCSI Hammer™ “SCSI Secure Erase” calls upon the firmware of the drive to execute and

monitor the erase procedure. Once this process is initiated on a drive, the user data storage area

becomes and remains unavailable until a successful “SCSI Secure Erase” is completed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 88 89

Sin comentarios

Seagate ST3300007LW Guía de usuario Pagina 9