Seagate Elite 9 Guía de instalación Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 40
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
Elite 9 Installation Guide, Rev. B 25
Write Protect
Reserved
J4A
DC Power
Connector
J4A
SCSI I/O
Connector
J4B
J01
Spinup delay equal to the SCSI bus ID multiplied by 10 seconds.
Valid only if the Start Command jumper is disconnected.
J4B
Spinup Delay Option
Pin 1
Immediate spinup. Valid only if the Start Command 
Option jumper is disconnected. (factory setting)
Start spindle after the SCSI bus sends a Start Unit command.
Start Command Option
Start spindle according to the Spinup Delay Option jumper. 
(factory setting)
Ignore parity check.
SCSI Bus Parity Check
Check the parity of data bytes read from the 
SCSI bus. (factory setting)
Reserved.
Write Enable (factory setting)
Pin 1
Active LED connector (+)
Ready LED connector (+)
Fault LED connector (+)
Ground (–)
LED Connections
Connect the anode to the desired LED 
connector and the cathode to the ground pin.
Figure 7. Additional jumper options
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Comentarios a estos manuales

Sin comentarios