
Verify NetBackup Access to SAN Devices
54 NetBackup ServerFree Agent System Administrator’s Guide
c. Click the Connectivity tab to find the world-wide port name of the device (Port
WWN). Repeat these steps for each device.
13. Update the “Device Checklist” on page 56 with the world-wide port names of your
devices.
Note It is important to record this information! It will be needed again, to complete the
configuration.
14. For Solaris: continue with “Solaris only: Configure HBA Drivers for Offhost Backup”
on page 57. For HP-UX, continue with “Create Offhost Backup Configuration Files”
on page 58.
Solaris only: Example for sg.links, sg.conf, and st.conf files
The following is an example for step 9 on page 52. For the devices in this example, fibre
channel LUNs 0, 1, 4, and 5 are needed for target (Loop ID) 6. In this example, LUN 0 is
the third-party copy device, LUN 1 is the tape controller, and LUNs 4 and 5 are the tape
drives.
Comentarios a estos manuales