Seagate ST3250824NS Guía para resolver problemas descargar pdf (Pagina 15)

Release Notes 15

4. In the terminal emulator, connect to controller A.

5. Press Enter to display the CLI prompt (#).

6. At the prompt, type the following command to list the current settings:

7. At the prompt, type the following command to set the values you recorded for each

Ethernet management port, first for controller A and then for controller B:

where:

■ address is the IP address of the controller

■ netmask is the subnet mask

■ gateway is the IP address of the subnet router

■ a|b specifies the controller whose network parameters you are setting

For example:

8. Type the following command to verify the new IP addresses:

9. In the host computer's command window, type the following command to verify

Ethernet connectivity, first for controller A and then for controller B:

show network-parameters

set network-parameters ip address netmask netmask gateway gateway

controller a|b

# set network-parameters ip 192.168.0.10 netmask 255.255.255.0

gateway 192.168.0.1 controller a

# set network-parameters ip 192.168.0.11 netmask 255.255.255.0

gateway 192.168.0.1 controller b

show network-parameters

ping IP-address

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Sin comentarios

Seagate ST3250824NS Guía para resolver problemas Pagina 15