Seagate Thin Manual Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 40
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
8 Momentus Thin Product Manual, Rev. E
3.8 Start/stop times
Time to ready Typical
Max @ 25°C
Power-on to Ready (sec) 3.5 4.0
Standby to Ready (sec) 3.0 3.0
3.9 Power specifications
The drive receives DC power (+5V) through a native SATA power connector.
3.9.1 Power consumption
Power requirements for the drives are listed in the table on p
age 8. Typical power measurements are based on
an average of drives tested, under nominal conditions, at 25°C ambient temperature. These power measure-
ments are done with Interface Power Management modes like HIPM and DIPM enabled.
Spinup power
Spinup power is measured from the time of power-on to the time
that the drive spindle reaches operating speed.
Seek mode
During seek mode, the read/write actuator arm moves toward
a specific position on the disk surface and does
not execute a read or write operation. Servo electronics are active. Seek mode power is measured based on
three random seek operations every 100ms. This mode is not typical.
Read/write power and current
Rea
d/write power is measured with the heads on track, base
d on three 63 sector read or write operations
every 100ms.
Idle mode power
Idle mode power is measured with the drive up to speed, with ser
vo electronics active and with the heads in
a random track location.
Standby mode
During Standby mode, the drive accepts commands, but the d
rive is not spinning, and the servo and read/
write electronics are in power-down model
Table 3: DC power
Power dissipation +5V input average (25° C)
Spinup (max) 1.00A
Seek 1.4W
Read 1.3W
Write 1.65W
Idle, performance* 1.1W
Idle, active* 0.68W
Idle, low power mode* 0.48W
Standby** 0.15W
Sleep 0.15W
*During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and
power to operational levels.
**Standby power is measured at steady state (after 200ms from transition)
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comentarios a estos manuales

Sin comentarios