Seagate ST1.2 - Series 8 GB Removable Hard Drive Manual descargar pdf (Pagina 15)

ST1.3 Series Product Manual, Rev. D

2.7.2 Conducted noise

Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on

the +3.3 volt line.

Using 3.3-volt power, the drive is expected to operate with a maximum of 70 mV peak-to-peak square-wave

injected noise at up to 20 MHz.

Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write

current.

2.7.3 Voltage tolerance

Voltage tolerance (including noise):

3.3V ± 5%

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Sin comentarios

Seagate ST1.2 - Series 8 GB Removable Hard Drive Manual Pagina 15